ATCA-9305 – 10G ATCA PACKET PROCESSING BLADE
通信I/O / AdvancedTCA
・Two Cavium OCTEON 16-core CN5860 processors operating at 800 MHz ・ATCA-9305-NSP version with 256MB RLDRAM for optimized deep packet inspection performance ・Cost-optimized ATCA-9305-SCP configuration without RLDRAM support ・Freescale MPC8548 PowerQuicc III integrated communications processor operating at 1 GHz ・Hardware acceleration with thread pin…
PEAZ-5565
通信I/O / その他の規格
・Local or remote monitoring options ・Flexible triggers ・Large trace buffer ・Complex trigers ・Local or remote Analyzer package installation ・Support for capturing and inspecting bad packets
PMC615RC
通信I/O / PMC/XMC
・Full duplex operation in both 10/100 modes ・PCI 66MHz capable ・Includes PIM ・J4 connectors ・Rear access I/O ・Four 10/100BaseTX Ethernet interface ・Pericom PIC8150 PCI bridge ・RoHS compliant
PMC676RCSC
通信I/O / PMC/XMC
・Jumbo Frames capable ・Full 1000Mbit point-to-point performance ・Dual or single 1000Mbit fiber Ethernet ・DMA engine ・Connector options SC ・Options: 1000BaseLX, single port, LC connectors, Solaris OBP boot option, PXE boot option, acrylic or polyurethane conformal coating ・PCI-X, PCI 64-bit/66MHz ・RoHS compliant
PCI-1553
通信I/O /
・Multi-function and single-function versions ・High-level API for Windows 2000, Me, NT, 98, 95, Linux, LabWindows/CVI, Visual Basic and VxWorks included ・Simultaneous Bus Controller, 31 Remote Terminals and Bus Monitor
ATC807
通信I/O / AdvancedTCA
・AdvancedTCA open standard form factor ・PICMG 3.1 compliant ・Managed Layer two 10GbE and 1GbE switch ・10GbE to the Fabric channel for 15 Node slots (option 9 or 1 selectable per port basis) ・GbE to Base Interface for 15 Node slots plus two Shelf ・Eight SFP+ cages for 10GbE ports (each port can run as GbE or 10GbE) ・Eight front panel 10/100/1000 Mbi…
AMC215
通信I/O / AdvancedMC
・AMC.2 compliant (XAUI based) ・10GbE via SFP+ ・XFI-to-XAUI operation ・Integrated Loopback and Line Timing Functionality ・Fully Adaptive Electronic Dispersion Compensation (EDC) ・Integrated BER Tester, and PRBS, Packet, and programmable Pattern Generation and checking. ・Compliant to applicable IEEE and INCITS specs
PMC-5565
通信I/O / PMC/XMC
・Error detection ・Redundant transfer mode for extra error suppression ・Any node on the network can generate an interrupt in any other node on the network or in all network nodes with a single command ・Two independent DMA channels ・64 Mbyte or 128 Mbyte SDRAM Reflective Memory ・Transfer rate 43 Mbyte/s (4 byte packets) to 174 Mbyte/s (64 byte packet…
PMC696LC
通信I/O / PMC/XMC
・Trunking capabilities ・Fail-over firmware ・64MB of DDR SDRAM onboard (optional 128MB) ・Options: 1000BaseLX ・PCI 64-bit / 66MHz ・LC connectors ・High performance RISC processor on board ・Dual 1000BaseSX Ethernet ports ・Not recommended for new designs
ASF-PC3
通信I/O /
・Commercial and extended temperature ranges available. ・Optional 48-bit IRIG-B clock input ・Single or dual channel ・ISA form factor ・Advanced Single Function (ASF)